Category Archives: Reflow oven

First SMD reflow attempt

The LED boards turned up from Seeedstudio today. Here’s one: That didn’t turn out too bad. The text for the resistor values is too small, I’ll know next time. I thought I’d better get on with it to see what … Continue reading

Posted in Reflow oven | Leave a comment

Reflow oven performance

Not had much time today for one reason or another… Didn’t have much luck with automatic tuning of the PID parameters for the oven. Did manage to knock it into shape manually though – there were some horrendous overshoots before … Continue reading

Posted in Reflow oven | Leave a comment

Reflow Oven – final hardware steps

Ok, picked up some block connectors at the local hardware store today. They didn’t have any of that fibreglass clad cable so I just went with what I had to hand. It’ll do 🙂 The above shows the use of … Continue reading

Posted in Reflow oven | Leave a comment

Reflow Oven – sorting out the 240V side…

Here’s a tear-down of the reflow oven. I was hoping to finish this tonight, but as you’ll see, it seems better to pick up a few bits I’m missing and do a far better job than the one I was … Continue reading

Posted in Reflow oven | Leave a comment

Towards a reflow oven controller

So, I found a suitable enclosure 😛 and went through my box of bits. I found an ATmega328 board that I must have built a while ago, that will be the microcontroller for this project. I dug out an LCD … Continue reading

Posted in Reflow oven | Leave a comment

Hinari “Tiny Top” Toaster Oven

Picked the “beasty” up this morning – I wish all eBay transactions were that smooth. It’s a great size for what I need so after no time at all I decided to test it. The oven is set to the … Continue reading

Posted in Reflow oven | Leave a comment